No Hassle Foundation Inspections

Foundation Issue? Call Today

(504) 592-7300

Replacing Sills on Your Home in Kenner Louisiana

Feb 16, 2023 | Sill Replacement

Replacing Sills on Your Home in Kenner Louisiana

Blog Introduction: Keeping your home in top condition is important for both aesthetic and safety reasons. One of the best ways to maintain its structural integrity is to replace sills when necessary. This article provides a detailed guide for replacing sills on your home in Kenner, Louisiana.

Step 1: Prepare the Work Area

Before you begin, make sure that you have all the tools and materials ready. You’ll need a hammer, pry bar, chisel, sawzall or reciprocating saw, drill and bits, scrap lumber, tape measure, level, caulking gun and caulk. Make sure the area around the sill is clear of any debris or furniture so you have room to work. You should also cover any nearby plants or shrubs with plastic sheeting to protect them from dust or debris.

Step 2: Remove the Old Sill

Using a hammer and chisel or pry bar, carefully remove any nails that are holding down the old sill. Once they are removed, use a sawzall or reciprocating saw to cut through any screws that may be holding it in place. Once all screws are removed, gently slide out the old sill from its place. Be careful not to damage surrounding surfaces as you do this.

Step 3: Measure and Cut New Sill

Once the old sill has been removed, take measurements of its length and width using a tape measure and transfer these measurements onto your new piece of wood using a pencil or marker. Use a sawzall or reciprocating saw to cut out your new piece of wood according to these measurements. Make sure that all edges are smooth with no splintering before proceeding further. Step 4: Install New Sill Place your new piece of wood into position where the old one was located using shims if needed for an even fit against existing walls and surfaces.

Secure it in place by drilling pilot holes then driving screws into them at regular intervals along all four sides of the sill until completely secured in place. Fill any gaps between wall/surface with caulking then wipe away any excess with damp cloth before allowing it to dry completely before proceeding further. Conclusion: Replacing sills on your home is an easy task but requires patience and attention-to-detail in order to ensure that it is done correctly and safely without damaging surrounding structures or surfaces. Follow these steps carefully while taking safety precautions such as wearing protective eyewear whenever necessary during each step of this process for best results when replacing sills on your home in Kenner Louisiana!

Call Now